Section

RESTRICTED					T. 0. No. 01-25C-3
	Page		Section		Page
I	Introduction	1			2.Classification of Damage	35
					3. Skin	36
	1. Type of Construction	1			4. Stringers	36
	2. Types of Repair	1			5. Longerons	36
	3. Extent of Damage	4			8. Bulkheads	51
	4. Support ot Structure During Repair	4
	5. Heat Treatment	4		V	Landing Gear	89
	6. Welding	4
	7. Bowed Tubes	4			1. General	89
	8. Solid Rivets	4			2. Bushing	89
	9. Removal of Countersumk Head Rivets	5
	10. Fitting Solid Rivets	5		VI	Wing	92
	11. Rivet Allowance -      Modified Brazier Head Rivet (871-D)	5			1. General	92
	12. Countersunk 18-DegreeR1vet(673-D)	5			2. Classification of Damage	92
	13. Countersunk 100-DegreeRivet (AN426)	5			3. Wing Skin	92
	14. Round-head Rivet (AN-130)	8			4. Ribs	93
	15. Flathead Rivet (AN442)	8			5. Spars	94
	16. Rivet Clearance	8			6. Stringers	95
	17. Operation of Cherry Blind Riveter	8			7. Spar Cap Strips	95
	18. Fitting Bolts	8			8. Flap	96
	19. Enlarged Holes	8			9. Ailerons	96
	20. Detecting the Presence of Cracks	8			10. wing Tip	97
	21. Marking-011	8
	22. Prevention of Corrosion	8		VII	Stabilizer and Fin	153
	23. Treatment of Parts	9
					1. General	153
II	Engine Mount	12			2. Stabilizer	153
	1. General	12			3. Fin	153
	2. Engine Mount Bushings	12
	3. Elongated Holes	12		VIII	Elevator and Rudder	165
III	Fuel, Oil, Hydraulic, and Cooling Systems	18			1. Mass Balancing	165
	1. Tanks	18			2. Elevator	165
	2. Radiators	25			3. Rudder	165
				IX	Miscellaneous Repair	175
IV	Fuselage	32			1. Engine Cowl	175
	1. General Discussion	32			2. Surface Controls	175
Figure Index

---

RESTRICTED